Cornelius 2 Flavor, 4 Flavor Bottle Adaptor - Sold Out Sensors, Bottle Adaptor - Tray Grommets

Quest Juice Training Manual

Tip:

When re-assembling the large o-ring may be pinched if not installed properly. Place the slide valve into the bottom of the adaptor keeping straight across. Press evenly to seat the o-ring. It is not advisable to rotate the valve back and forth in and attempt to seat the o-ring. Do the same when installing the top.

When securing the screws do it in the X pattern tightening the opposites across from each other. Be sure the are fully tighten to prevent leaking.

1

4

3

2

Bottle Adaptor - Sold Out Sensors

The sold-out sensors are located in the bottle adaptor neck.

The do not get cleaned during normal flushing procedures. They are cleaned only during sani- tizing.

Be sure there is no build up of pulp or concen- trate on the pins themselves. The results will be an erratic operation of the refill lights.

Sold Out Contacts

Bottle Adaptor - Tray Grommets

When installing the grommets be sure that each one is sealed below the lead in taper on the top of the bottle adaptor.

TIP: Press the entire tray down evenly to seat Run finger around the edge to seal.

© 2004, IMI Cornelius Inc. - 31 - Publication Number: TP00968