Quest Juice Training Manual
REMOVAL OF THE VRB BOARDS
1. Remove the cover.
2.Remove the connectors.
3.Loosen and remove the nut and insulation.
4.Turn the box over and locate the standoffs on the VRB board to be removed. Gently squeeze with a needle nose pliers. This will release the standoff and allow it to be pushed back through the hole in the bracket.
5.The VRB board can now be removed from the electrical box itself.
6.The standoffs (4) can be removed by gently squeezing the tip with needle nose pliers and at the same time pushing through the board.
NOTE: The nut and insulation must be assembled as illustrated. Failure to assemble and tighten correctly can result in component overheating causing the concentrate pump not to run.
Publication Number: TP00968 | - 20 - |
Lock washer
Washer
Insulator pad
Insulator washer
© 2004, IMI Cornelius Inc.
