Software Installation 33
Table 5 describes the command syntax, the mode you must be in to execute the command, and the purpose and output of the command.
Table 5. Quick Start Commands
Command | Mode | Description |
|
|
|
show hardware | Privileged | Shows hardware version, MAC address, and software ver- |
| EXEC | sion information. |
show users | Privileged | Displays all of the users that are allowed to access the net- |
| EXEC | working device. |
|
| Access Mode shows whether the user is able to change |
|
| parameters on the networking device (Read/Write) or is |
|
| only able to view them (Read Only). |
|
| As a factory default, the ‘admin’ user has Read/Write |
|
| access and the ‘guest’ user has Read Only access. There |
|
| can only be one Read/Write user and up to five Read Only |
|
| users. |
|
|
|
show | User EXEC | Displays all of the login session information. |
loginsession |
|
|
users passwd | Global Config | Allows the user to set passwords or change passwords |
<username> |
| needed to login. |
|
| A prompt appears after the command is entered requesting |
|
| the users old password. In the absence of an old password |
|
| leave the area blank. |
|
| User password should not be more than eight characters in |
|
| length. |
|
|
|
copy sys- | Privileged | Saves passwords and all other changes to the device. |
tem:running- | EXEC | If you do not save the configuration, all changes are lost |
config |
| when you power down or reset the networking device. |
nvram:startup- |
|
|
config |
|
|
logout | User EXEC | Logs the user out of the networking device. |
| Privileged |
|
| EXEC |
|
|
|
|
