40 Web User Guide

NOTE: If SNMPv3 Authentication is to be used for this user, the password must be eight or more alphanumeric characters.

5.If you do not need authentication, go to Step 9.

6.To enable authentication, use the Authentication Protocol pulldown menu to select either MD5 or SHA for the authentication protocol.

7.If you do not need encryption, go to Step 9.

8.To enable encryption, use the Encryption Protocol pulldown menu to select DES for the encryp- tion scheme. Then, enter in the Encryption Key field an encryption code of eight or more alphanu- meric characters.

9.Click Submit.

Command Buttons

The following command buttons are used throughout the Web interface panels for the switch:

Save

Pressing the Save button implements and saves the changes you just made. Some set-

 

tings may require you to reset the system in order for them to take effect.

Refresh

Pressing the Refresh button that appears next to the Apply button in Web interface

 

panels refreshes the data on the panel.

Submit

Pressing the Submit button sends the updated configuration to the switch. Configura-

 

tion changes take effect immediately, but these changes are not retained across a

 

power cycle unless a save is performed.

Page 40
Image 40
D-Link d-link manual Command Buttons, Save