DES-3326S Layer 3 Fast Ethernet Switch User’s Guide

The COMMAND field specifies an operation according the following table:

Command

Meaning

1Request for partial or full routing information

2Response containing network-distance pairs from sender’s routing table

3Turn on trace mode (obsolete)

4Turn off trace mode (obsolete)

5Reserved for Sun Microsystem’s internal use

9Update Request

10Update Response

11Update Acknowledgement

Table 5-15. RIP Command Codes

The field VERSION contains the protocol version number (1 in this case), and is used by the receiver to verify which version of RIP the packet was sent from.

RIP 1 Message

RIP is not limited to TCP/IP. Its address format can support up to 14 octets (when using IP, the remaining 10 octets must be zeros). Other network protocol suites can be specified in the Family of Source Network field (IP has a value of 2). This will determine how the address field is interpreted.

RIP specifies that the IP address 0.0.0.0 denotes a default route.

124

Switch Management and Operating Concepts

Page 124
Image 124
D-Link DES-3326S manual RIP 1 Message, 124