D-Link DES-3326S manual Switch Stack Display, 196

DES-3326S Layer 3 Fast Ethernet Switch User’s Guide

management agent. To change a switch’s order in the stack, you must use the console Command Line Interface.

The number of switches in the switch stack (up to 6 − total) are displayed in the upper right-hand corner of you web-browser. The icons are in the same order as their respective Unit numbers, with the Unit 1 switch corresponding to the icon in the upper left-most corner of the icon group.

Figure 6-15. Switch Stack Display

In this case, there are two switches in the switch stack. The Unit 1 (master) switch is on top and highlighted in blue. The Unit 2 (slave) switch is below and not highlighted. To select a switch in the switch stack to configure, simply click on the corresponding switch’s icon.

Figure 6-16. Switch Stack Icons

Here, the switch Unit 2 (slave) has been selected.

When the up to 6 DES-3326S switches are properly interconnected through their optional Stacking Modules, information about the resulting switch stack is displayed under the Stack Information link. This link is visible only when a switch stack has been connected and the optional Stacking Modules are active.

196 Web-Based Switch Management