D-Link DES-3326S manual User-Changeable STA Parameters, Feature Default Value

DES-3326S Layer 3 Fast Ethernet Switch User’s Guide

When STP is enabled, every port on every switch in the network goes through the blocking state and then transitions through the states of listening and learning at power up. If properly configured, each port stabilizes to the forwarding or blocking state.

No packets (except BPDUs) are forwarded from, or received by, STP enabled ports until the forwarding state is enabled for that port.

Default Spanning-Tree Configuration

Feature	Default Value
Enable state	STP enabled for all ports
Port priority	128
Port cost	19
Bridge Priority	32,768
	Table 5-7. Default STP Parameters

User-Changeable STA Parameters

The factory default setting should cover the majority of installations. However, it is advisable to keep the default settings as set at the factory; unless, it is absolutely necessary. The user changeable parameters in the Switch are as follows:

•Priority A Priority for the switch can be set from 0 to 65535. 0 is equal to the highest Priority.

•Hello Time The Hello Time can be from 1 to 10

seconds. This is the interval between two

Switch Management and Operating Concepts 65