Getting Started

Connecting the Scanner

The scanner kit you ordered to match your interface should provide a compatible cable for your installation. Alternatively, if your scanner receives Power Off the Terminal (POT) it might be possible to connect using a cable from a previously existing installation (except for USB). If you wish to connect using an existing cable, but cannot use POT, a short adapter cable is available. Check with your technical support representative about compatibility before connecting. Use the appropriate instructions below when you’re ready to connect the scanner to the terminal, PC or other host device.

Upon completing the connection via the appropriate interface instructions below, proceed to the Interface Related Features section of this manual and scan the bar code to select the correct interface type.

RS-232 Serial Connection — Turn off power to the terminal/PC and connect the scanner to the terminal/PC serial port via the RS-232 cable as shown in Figure 1a. If the terminal will not support POT (Power Off the Terminal) to supply scanner power, use the approved power supply (AC Adapter) as shown in Figure 1b. Plug the AC Adapter barrel connector into the socket on the RS-232 cable connector and the AC Adapter plug into a standard power outlet.

Figure 1. Connecting the Scanner

a

Terminal (PC)

 

S

B

U

 

or...

M

Power Off

IB

 

 

 

the Terminal or...

-2

2

3

(POT)

S

 

R

 

 

 

Keyboard

Wedge

b

Keyboard Wedge, RS-232

and USB Cables

Powered by AC Adapter

To Terminal (PC)

R

 

U

S

 

S

2

 

-

2

B

3

 

c

Other Non-POT Cables Powered by AC Adapter via short adapter cable

To Terminal (PC)

2

MagellanTM 3200VSi

Page 10
Image 10
Datalogic Scanning 3200VSI manual Connecting the Scanner