Datalogic Scanning 3200VSI manual Wall Mount, Countertop Mount

Mount Installation

Figure 3. Using the Risers

a	One Riser	b	Two Risers stacked. Scanner and
			L-Bracket have been tilted on the
			top Riser.

Wall Mount

Attach the L-Bracket to the wall, securing it in the desired position with two screws through the two holes in the back face of the L-Bracket as shown in Figure 2. Recommendation: Use two Pan Head (8.2mm or 5/16” maximum head diameter) #8 screw with a thread profile that suits the mounting surface material in the wall.

Countertop Mount

If using the L-Bracket alone for countertop installation, secure the bracket in place using two screws through the bottom face of the bracket (see Figure 2). If risers are used, secure a riser to the countertop by attaching two screws through its screw holes. Recommendation: Use two Pan Head (8.2mm or 5/16” maximum head diameter) #8 screw with a thread profile that suits the mounting surface material in the countertop.

Do not use a countersink type of screw head. Damage will occur from use of a countersunk screw head in the plastic screw bosses

CAUTION

Risers may be stacked as shown in Figure 3b. Each riser increments the height of the mounted scanner by 1.5” (38.1mm). Riser pieces readily snap together or apart and allow for adjustable tilt of the scanner/L-Bracket of up to 20 degrees in 5° increments. Figure 3b provides an example of a tilted scanner.

Product Reference Guide 5