Datalogic Scanning 3200VSI manual Error Codes

Error Codes

USB Connection — Connect the scanner to a USB port on the terminal/PC using the correct USB cable for the interface type you ordered. Reference Figure 1.

	USB installations may require a power connection via an approved A/C
	Adapter as shown in Figure 1b or Figure 1c. For example, this would be
	the case if the scanner is connected along with a number of other devices
NOTE	to a non-powered USB hub.

IBM Connection — Connect the scanner to the IBM port on the terminal/PC using the cor- rect IBM cable. Reference Figure 1.

Keyboard Wedge Connection — Before connection, turn off power to the terminal/PC. The Keyboard Wedge cable has a ‘Y’ connection from the scanner. Connect the female to the male end from the keyboard and the remaining end at the keyboard port at the terminal/PC. Reference Figure 1a.

Error Codes

If an error is detected, the scanner will sound a long low tone (for three seconds) and flash its LED, indicating a failure. When this occurs, press the Scanner Pushbutton to hear the error code. If it is configured to do so, the scanner will sound a series of beeps corresponding to the error code and/or flash its LED simultaneous to the beeps. The table below describes what these codes mean and what action should be taken for each.

NUMBER OF
LED FLASHES/	ERROR	CORRECTIVE ACTION
BEEPS
1	Configuration
2	Interface PCB
6	Main PCB
10	Button Error	Contact Helpdesk for assistance
12	Imager Module
13	Software ID Failure
14	Software Fatal Fault

Product Reference Guide 3