Datalogic Scanning 3200VSI manual ERI Timeout

General Features

ERI Timeout

Specifies the amount of time the External Read Indicator (ERI) signal is held active for a good read.

START / END

PROGRAMMING bar codes

Sets the ERI timeout duration using hex values from 000 to 255 in increments of ten milliseconds (10ms or 0.01 seconds). To config- ure this feature, scan the “START/END” bar code above to place the unit in Programming Mode, then the “Set ERI Timeout,” followed by the two digits (zero padded) from the Alphanumeric table in Appendix C, Alpha-Numeric Pad representing the desired time value. Exit programming mode by scanning the “START/END” bar code again.

DEFAULT SETTING FOR THIS FEATURE: 20 milliseconds (02)

Set ERI Timeout

24 MagellanTM 3200VSi