Datalogic Scanning 3200VSI manual Global Prefix/Suffix

Global Prefix/Suffix

Global Prefix/Suffix — cont.

START / END

PROGRAMMING bar codes

Sets up to 20 characters each from the set of ASCII characters or any hex value from 00 to FF. To configure this feature, scan the “START/END” bar code above to place the unit in Programming Mode, then the “Set Prefix” or “Set Suffix,” followed by the digits from the Alphanumeric table in Appendix C, Alpha-Numeric Pad representing your desired character(s). Reference the section, "Example: Setting a Prefix", for more information. Exit programming mode by scanning the “START/END” bar code again (scan “START/END” twice if less than 20 characters have been selected).

DEFAULT SETTING PREFIX: 00 (None)

DEFAULT SETTING SUFFIX: 0D (CR)

Set Prefix

Set Suffix

Product Reference Guide 75