63 Replacing the Camera Module

WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in "Before You Begin" on page 11. After working inside your computer, follow the instructions in "After Working Inside Your Computer" on page 13. For additional safety best practices information, see the Regulatory Compliance Homepage at dell.com/ regulatory_compliance.

Procedure

1Slide the camera module into the camera assembly.

2Tighten the captive screw that secures the camera module and the grounding cable to the camera assembly.

3Connect the camera cable to the camera assembly and place the camera in the computer base.

4Replace the screws that secure the camera assembly to the computer base.

Postrequisites

1Follow step 8 to step 19 in "Replacing the Display Panel" on page 139.

2Replace the inner frame. See "Replacing the Inner Frame" on page 97.

3Replace the processor heat-sink fan. See "Replacing the Processor Heat-Sink Fan" on page 77.

4Replace the trim cover. See "Replacing the Trim Cover" on page 89.

5Replace the system-board shield. See "Replacing the System-Board Shield" on page 33.

6Replace the stand. See "Replacing the Stand" on page 49.

7Replace the back cover. See "Replacing the Back Cover" on page 21.

Replacing the Camera Module 143

Page 143
Image 143
Dell 2710 owner manual Replacing the Camera Module