82 Installing System Components
4
Install the integrated storage controller card in place. See Figure3-14.
5
Connect the SAS data cable to the integrated storage controller card.
6
Close the system. See "Closing the System" on page 59.
7
Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
RAID Battery (Optional) NOTE: The information in this section applies only to systems with the optional
RAID controller card.
Removing a RAID Battery
CAUTION: Many repairs may only be done by a certified service technician.
Youshould only perform troubleshooting and simple repairs as authorized in
yourproduct documentation, or as directed by the online or telephone service
andsupport team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
withthe product.
1
Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
2
Open the system. See "Opening the System" on page 58.
3
Locate the RAID battery carrier and remove the two screws that secure the
RAID battery carrier on to the chassis. See Figure3-15.
4
Pull back gently on the right edge of the battery bay and draw out the
RAID battery from the battery carrier.
5
Disconnect the cable between the RAID battery and the storage controller
card. See Figure3-15.
book.book Page 82 Monday, April 12, 2010 3:38 PM