Installing System Components 73
Figure 3-13. Removing and Installing the Integrated Storage Controller Card
Installing the Integrated Storage Controller Card
1
Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
2
Open the system. See "Opening the System" on page 53.
3
Place the three spacer pins on the system board. See Figure3-13.
4
Install the integrated storage controller card in place. See Figure3-13.
5
Connect the SAS data cable to the integrated storage controller card.
6
Close the system. See "Closing the System" on page54.
7
Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
1 spacer pins (3) 2 integrated storage controller card
3 SAS cables connector
3
2
1
book.book Page 73 Friday, December 4, 2009 4:13 PM