92 Installing System Components
Figure 3-25. Removing and Installing the System Battery
Installing the System Battery
1
Support the battery connector by pressing down firmly on the positive side
of the connector.
2
Hold the battery with the "+" facing up, and slide it under the securing
tabs at the positive side of the connector.
3
Press the battery straight down into the connector until it snaps into place.
4
Install the cooling shroud. See "Installing the Cooling Shroud" on page55.
5
Close the system. See "Closing the System" on page 54.
6
Reconnect the system to the electrical outlet and turn the system on,
including any attached peripherals.
7
Enter the System Setup program to confirm that the battery is operating
properly. See "Using the System Setup Program" on page33.
8
Enter the correct time and date in the System Setup program's
Time
and
Date
fields, and re-enter any customized option settings as needed.
9
Exit the System Setup program.
1 positive side of battery connector 2 system battery
3 negative side of battery connector
3
1
2
book.book Page 92 Friday, December 4, 2009 4:13 PM