Installing the RAID Battery

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1Insert the RAID battery into the battery carrier until it locks into place. See Figure 3-21.

2Connect the cable to the battery. See Figure 6-1.

3Close the system. See "Closing the System" on page 65.

4Turn on the system and attached peripherals.

Control Panel Assembly—LED

Removing the Control-PanelModule–LED

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1If installed, remove the front bezel. See "Removing the Front Bezel" on page 63.

2Turn off the system and attached peripherals, and disconnect the system from the electrical outlet and peripherals.

3Remove the single screw securing the bracket to the module and remove the bracket.

4Disconnect the control-panel cable at back of the module by using the pull tab. See Figure 3-22.

CAUTION: Do not pull on the cable to unseat the connector. Doing so can damage the cable.

5Remove the screw securing the power button board to the control-panel module. See Figure 3-22.

112

Installing System Components

Page 112
Image 112
Dell DL2200 owner manual Control Panel Assembly-LED, Installing the RAID Battery, Removing the Control-PanelModule-LED