Front-Panel I/O Module
Removing the Front-Panel I/O Module
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
1If installed, remove the front bezel. See "Removing the Front Bezel" on page 63.
2Turn off the system and attached peripherals, and disconnect the system from the electrical outlet and peripherals.
3Using a Torx screwdriver, remove the three screws that secure the front panel I/O module to the system chassis and remove the module.
4Remove the single screw securing the bracket to the module and remove the bracket.
5Unlatch and disconnect the
CAUTION: Do not pull on the cable to unseat the connector. Doing so can damage the cable.
Installing System Components
115
