Installing the System Board

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1Unpack the new system board.

2Remove the labels from the processor shield and affix them to the system identification panel on the front of the system. See Figure 1-1.

3Holding the system board by the edges, lower the system board into the chassis.

CAUTION: Do not lift the system board assembly by grasping a memory module, processor, or other components.

4Slightly lift up the front of the system board and maneuver the system board to the bottom of the chassis until it lays completely flat.

5Push the system board toward the back of the chassis until the board is in place.

6Tighten the nine screws that secure the system board to the chassis. See Figure 3-26.

7Transfer the processors to the new system board. See "Removing a Processor" on page 103 and "Installing a Processor" on page 107.

8Remove the memory modules and transfer them to the same locations on the new board. See "Removing Memory Modules" on page 87 and "Installing Memory Modules" on page 85.

9Connect the cables to the system board. See Figure 6-1 for the locations of the connectors on the system board.

10Replace the expansion-card riser. See "Installing an Expansion-Card Riser" on page 94.

11Install all expansion cards. See "Installing an Expansion Card" on page 90.

12If applicable, reinstall the storage controller card. See "Installing the Storage Controller Card" on page 97.

After connecting the SAS cables to the controller, make sure to place the cables under the guide on the end of riser 1.

126

Installing System Components

Page 126
Image 126
Dell DL2200 owner manual Installing the System Board, Unpack the new system board