Replacing a Cooling Fan
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
1Align the fan module so that the side with the power cable faces toward the back of the system.
2Slide the fan module into the fan assembly until the fan is fully seated. See Figure
3Connect the fan’s power cable to the power connector on the system board.
4Replace the internal
5Route the power cable through the guides on the chassis.
6Replace the cooling shroud. See "Installing the Cooling Shroud" on page 67.
7Close the system. See "Closing the System" on page 65.
8Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Power Supplies
Your system supports two 750 W redundant power supply modules.
NOTE: The maximum output power (shown in watts) is listed on the power supply label.
If two power supplies are installed, the second power supply provides
CAUTION: To ensure proper system cooling, the power supply blank must
be installed in the PS2 bay. See "Installing the Power Supply Blank" on page 80".
Installing System Components
77