Dell E20S001 owner manual 111

Figure 60. Removing and Installing the Control-Panel Assembly in a Rack-Mode System

1.	LCD module ZIF connector	2.	VGA module connector
3.	VGA module cable connector	4.	control-panel assembly connector
5.	control-panel assembly cable connector	6.	screw
7.	control-panel board	8.	VGA module

9.control panel for rack mode

7.If you are replacing the control-panel assembly, remove the information tag by following the steps below:

a.Locate the tabs on the information tag.

b.Use a flat screwdriver to press the tabs on the tag one at a time.

c.Pull the information tag out of the slot to remove it from the control-panel assembly.

NOTE: Retain the information tag for replacement in the new control-panel assembly.

Figure 61. Removing and Installing the Information Tag

1. information tag 2. tabs (2)

111