Figure 47. Removing and Installing the iDRAC Ports Card
1. screw | 2. iDRAC ports card |
3.iDRAC ports card connector
Installing The iDRAC Ports Card
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
1.Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
2.If applicable, rotate the system feet inward and lay the system on its side on a flat, stable surface.
NOTE: For systems installed with the wheel assembly, ensure that you lay the system on a sturdy, stable surface with the wheel assembly extending off the edge of the surface.
3.Open the system.
4.Remove the cooling shroud.
5.If there is a filler bracket in the iDRAC ports card slot, remove the screw and lift the filler bracket out of the system.
6.Insert the iDRAC ports card into the connector on the system board.
7.Secure the iDRAC ports card using the screw.
8.Install the cooling shroud.
9.Close the system.
10.If applicable, place the system upright on a flat, stable surface and rotate the system feet outward.
92
