NOTE: For systems installed with the wheel assembly, ensure that you lay the system on a sturdy, stable surface with the wheel assembly extending off the edge of the surface.
3.Open the system.
4.Locate the USB connector (INT USB) or the USB key on the system board.
5.If applicable, remove the USB key.
6.Insert the new USB key into the USB connector.
7.Close the system.
8.If applicable, place the system upright on a flat, stable surface and rotate the system feet outward.
9.Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
10.Enter the System Setup and verify that the USB key is detected by the system.
Figure 43. Replacing the Internal USB Key
1. USB key | 2. USB connector |
84
