7.From inside the system, press and push out the expansion card release latch to open it.
8.Holding the card by its edge, pull the card to disengage from the connector and lift the card out of the chassis.
9.If you are removing the card permanently, install a filler bracket in the empty card slot.
NOTE: Filler brackets must be installed over empty
10.From outside the system, rotate the expansion card latch toward the system until it snaps into place.
11.If applicable, install the PCIe card holder.
12.Close the system.
13.If applicable, place the system upright on a flat, stable surface and rotate the system feet outward.
14.Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Figure 45. Removing and Installing the Expansion Card
1.expansion card latch
2.expansion card connector
3.expansion card
Installing An Expansion Card
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
1.Unpack the expansion card and prepare it for installation.
For instructions, see the documentation accompanying the card.
2.Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
3.If applicable, rotate the system feet inward and lay the system on its side on a flat, stable surface.
88
