Philips DVDR80 manual AMy external receiver does not display the programme number

aMy external receiver does not display the programme number

During installation, the external receiver will be switched to a different programme number. If the receiver does not display the programme number, you must check the 'Video window' (left top corner in the GUIDE Plus+® system) to see whether switching has taken place. The connection socket of the receiver will be automatically selected.

1Please check the TV show in the 'Video window' in the left top corner of the screen.

2 Check whether the picture changes during the next step ( OK ). Problem

4Read the information on the screen carefully. Confirm with OK .

The DVD recorder will now attempt to use the G-Link connection on the external receiver to select a different programme number (e.g.09). This programme number depends on your external receiver.

5Has the external receiver been switched to the programme number displayed on the screen?

If this is the case, select 'YES'.

If no switching has taken place, select 'NO'.

aMy external receiver has not switched to the other programme number.

1Check that the external receiver is connected and switched on.

2 Check the connection and position of the G-LINK transmitter.

3 For another attempt with a new code of the chosen brand, select 'NO'. 4 Confirm with OK on the remote control.

5 If the receiver has not switched yet, select 'NO' again and confirm with OK . It may take several attempts for a receiver brand.

If you return to the setup screen after confirming 'NO', your receiver may not have been installed. Check the connections again.

6 If all connections are o.k., please note the type and manufacturer of your external receiver and call the customer support service in your country. You will find the telephone number on the back of this instruction manual.

The control data of the external receivers are automatically updated (completed) via the GUIDE Plus+® system. This is done through the

aerial, the cable, or the external receiver. You do not need to bring the	Problem
device to a service centre.

6Your external receiver has now been installed.

7Press OK to return to the setup overview.

aI want to install additional external receivers
When installing additional external receivers, please observe the following:
The external receiver which is controlled by the G-LINK transmitter must
be below the other additional receivers. The IR(infrared) remote control
signal is reflected diagonally upwards and can therefore be used to control	Problem
additional external receivers which are on top.

42 The GUIDE Plus+® System