
PROBLEMSOLUTION
The wrong TV channel was decoded (entered) after you programmed a recording using VIDEO Plus+ System.
There is no channel overview in the GUIDE Plus+® system
Missing or wrong TV channel in the 'Grid' screen
When you press GUIDE/TV the GUIDE Plus+® setup screen will appear
The external receiver does not always react to Remote control signal.
My external receiver switches automatically through the TV channels
There is picture or sound interference on TV reception:
bThe programme number of the TV channel is not available in the GUIDE Plus+® system or allocation is wrong.
To change or check the channel data, proceed as follows:
1Press GUIDE/TV .
2Press P+ A .
3Select 'Editor' with C .
4Select the TV channel using P- B or P+ A .
5Press C to go to the right tile.
In case you can receive the selected channel only via an external receiver, press the red button to select the corresponding source.
6Press the green button.
7Enter the programme number of the TV channel using the number buttons.
If the source you have selected is an external receiver, enter the programme number that you would also enter at the external receiver for this TV channel.
8Confirm with OK .
bDVD recorder is switched on: Switch off the DVD recorder to allow data transfer bThe TV channel that transmits the GUIDE Plus+® data is not set properly.
bExternal receiver (satellite receiver,
'External receiver 1'').
bWrong local post code/country was entered
bPlease check your correct channel line up in the 'Grid' screen. Read therefore the section 'The 'Editor' screen.
bThe GUIDE Plus+® system was not completely installed or local post code was not entered.
1Check the settings
2Select the corresponding line using P- B or P+ A and confirm with OK .
3For more information on the individual functions, see chapter 'The GUIDE Plus+® system', section 'Installation of the 'External receiver 1''.
bThe Infrared (IR) Remote control signal interfere with the IR signal of the
bIf the
bBefore recording, select the recording mode as described in chapter 'Manual Recording', section 'Selecting the recording mode (quality)'.
bHave your aerial checked.
bYou will find information on how to change the TV system in 'Manual TV channel search' in 'Installing your DVD recorder'.
106 | Before you call an engineer |
|