Dell E30S owner manual Installing the power interposer board

Figure 54. Removing and installing the power interposer board

1.	GPU power connector	2.	power interposer board
3.	release latch	4.	hooks (4)

5.slots (4)

Related Links

Removing a redundant AC power supply

Removing the cooling shroud

Installing the power interposer board

Installing the power interposer board

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

Ensure that you read the Safety instructions.

Steps

1.Align the slots on the power interposer board (PIB) with the hooks on the power supply cage and slide the PIB until it snaps into place.

2.Route the power cables through the securing clips as applicable, and connect the power cables to the system board.

3.Route the P3 power cable through the securing clip on the system board and connect power cable to the hard-drive backplane.

127