Dell E30S Indicator, button, or, Icon, Description, connector, turned off, NMI button, paper clip

Item	Indicator, button, or	Icon	Description
	connector
			NOTE: On ACPI-compliant operating systems,
			turning off the system using the power button
			causes the system to perform a graceful
			shutdown before power to the system is
			turned off.
2	NMI button		Used to troubleshoot software and device driver
			errors when running certain operating systems.
			This button can be pressed using the end of a
			paper clip.
			Use this button only if directed to do so by
			qualified support personnel or by the operating
			system documentation.
3	System identification		The identification buttons on the front and back
	button		panels can be used to locate a particular system
			within a rack. When one of these buttons is
			pressed, the LCD panel on the front and the
			system status indicator on the back flash until one
			of the buttons is pressed again.
			Press to toggle the system ID on and off.
			If the system stops responding during POST, press
			and hold the system ID button for more than five
			seconds to enter BIOS progress mode.
			To reset iDRAC (if not disabled in <F2> iDRAC
			setup) press and hold for more than 15 seconds.
4	LCD menu buttons		Allow you to navigate the control panel LCD menu.
5	Information tag		A slide-out label panel which contains system
			information such as Service Tag, NIC, MAC
			address, and so on for your reference.
6	LCD panel		Displays system ID, status information, and system
			error messages. See LCD panel features.
			NOTE: The LCD panel is not available in a
			cabled hard-drive system.
7	USB management port/		The USB management port can function as a
	iDRAC Direct port		regular USB port or provide access to the iDRAC
			Direct features. For more information, see the
			iDRAC Guide at dell.com/esmmanuals.
			This port is USB 2.0-compliant
8	Video connector		Allows you to connect a display to the system.

12