2. Installation
2.1. Installing the Imprinter
Install the imprinter as follows:
1.Switch off the Scanner and disconnect the electrical power cable.
2.Remove the Stacker from the scanner.
cLift the Stacker about 45°.
dAt the end of the Stacker, where attached to the scanner, press down on the lower center of the Stacker to release it and gently pull the Stacker away.
3.Remove the cover (black) located under the stacker.
ATTENTION | You must remove the stacker and black cover |
| before installing the Imprinter to the Scanner. |
4.Install the Imprinter to the Scanner.
cCheck the insertion direction of the Attachment Guide.
Attachment Guide
ADF
dCheck the Shaft from below.
ADFShaft
Scanner
eLocate the Attachment Guide along the Shaft.
Shaft
fPush up the Attachment Guide.
