Dell NY105 manual Before Working Inside Your Computer

Before Working Inside Your Computer

Use the following safety guidelines to help protect your computer from potential damage and to help ensure your own personal safety.

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

CAUTION: Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by its edges or by its metal mounting bracket. Hold a component such as a processor by its edges, not by its pins.

NOTICE: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is not covered by your warranty.

NOTICE: When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself. Some cables have a connector with locking tabs; if you are disconnecting this type of cable, press in on the locking tabs before you disconnect the cable. As you pull connectors apart, keep them evenly aligned to avoid bending any connector pins. Also, before you connect a cable, ensure that both connectors are correctly oriented and aligned.

NOTICE: To avoid damaging the computer, perform the following steps before you begin working inside the computer.

1Ensure that the work surface is flat and clean to prevent the computer cover from being scratched.

2Turn off your computer (see "Turning Off Your Computer" on page 109).

3If the computer is connected to a docking device (docked), undock it. See the documentation that came with your docking device for instructions.

NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall connector.

4Disconnect any telephone or network cables from the computer.

5Close the display and turn the computer upside down on a flat work surface.

NOTICE: To avoid damaging the system board, you must remove the main battery before you service the computer.

6Remove any installed modules, including a second battery, if installed (see "Media Bay" on page 128).

7Disconnect your computer and all attached devices from their electrical outlets.

8Remove the battery (see "Replacing the Battery" on page 36).

9Press the power button to ground the system board.

10Remove any installed PC Cards from the PC Card slot (see "Removing a Card or Blank" on page 65).

110

Adding and Replacing Parts