1

2

1 screws (2)

2 hard drive

NOTE: The number of hard drive screws may vary.

2Remove the hard drive screws on the bottom of the computer.

NOTICE: When the hard drive is not in the computer, store it in protective antistatic packaging. See "Protecting Against Electrostatic Discharge" in the Product Information Guide.

3Slide the hard drive out of the computer.

4Remove the new drive from its packaging.

Save the original packaging for storing or shipping the hard drive.

NOTICE: Use firm and even pressure to slide the drive into place. If you use excessive force, you may damage the connector.

5Slide the hard drive into the bay until it is fully seated.

6Replace and tighten the screws.

7Use the Operating System media to install the operating system for your computer (see "Using the Operating System Media" on page 106).

8Use the Drivers and Utilities media to install the drivers and utilities for your computer (see "Reinstalling Drivers and Utilities" on page 102).

Adding and Replacing Parts

127

Page 127
Image 127
Dell NY105 manual 127, Screws Hard drive