Dell PP10S owner manual System Setup Screens, Commonly Used Options, Changing the Boot Sequence

w w w . d e l l . c o m s u p p o r t . d e l l . c o m

System Setup Screens

NOTE: For information about a specific item on a system setup screen, highlight the item and see the Help area on the screen.

On each screen, the system setup options are listed at the left. To the right of each option is the setting or value for that option. You can change settings that appear as white type on the screen. Options or values that you cannot change (because they are determined by the computer) appear less bright.

The upper-right corner of the screen displays help information for the currently highlighted option; the lower-right corner displays information about the computer. System-setup key functions are listed across the bottom of the screen.

Commonly Used Options

Certain options require that you reboot the computer for new settings to take effect.

Changing the Boot Sequence

The boot sequence, or boot order, tells the computer where to look to find the software needed to start the operating system. You can control the boot sequence and enable/disable devices using the Boot Order page of system setup.

NOTE: To change the boot sequence on a one-time-only basis, see "Performing a One-Time Boot" on page 89.

The Boot Order page displays a general list of the bootable devices that may be installed in your computer, including but not limited to the following:

•USB Diskette Drive

•Hard Drive

•ATAPI CD-ROM Drive

•Network

•Diagnostics

NOTE: You can only boot (start up) your computer from a CD, CD-RW, or DVD drive installed as a fixed drive.

During the boot routine, the computer starts at the top of the list and scans each enabled device for the operating system start-up files. When the computer finds the files, it stops searching and starts the operating system.

To control the boot devices, select (highlight) a device by pressing the down-arrow or up-arrow key and change its order in the list. To reorder a device in the list, highlight the device and then press <F5> or <F6> to move the highlighted device up or down.

Boot sequence changes take effect as soon as you save the changes and exit system setup.

88

Appendix