SAFETY INFORMATION
PRODUCT IDENTIFICATION 3 LOCAL CODES
SAFETY INFORMATION
Continued
PRODUCT IDENTIFICATION
5. | This fireplace reaches high temperatures, Keep children and |
| adults away from hot surfaces to avoid burns or clothing igni- |
| tion. Fireplace will remain hot for a time after shutdown. Al- |
| low surfaces to cool before touching. |
6. | Carefully supervise young children when they are in the room |
| with fireplace. |
7. | Do not modify this fireplace under any circumstances. Any |
| parts removed for servicing must be replaced prior to operat- |
| ing fireplace. |
8. | Turn fireplace off and let cool before servicing, installing, or |
| repairing. Only a qualified service person should install, ser- |
| vice or repair this fireplace. Have fireplace inspected annu- |
| ally by a qualified service person. |
9. | You must keep control compartments, burners, and circulat- |
| ing air passages clean. More frequent cleaning may be needed |
| due to excessive lint and dust from carpeting, bedding mate- |
| rial, etc. Turn off the gas valve and pilot light before cleaning |
| fireplace. |
10. | Have venting system inspected annually by a qualified service |
| person. If needed, have venting system cleaned or repaired. |
| See Cleaning and Maintenance, page##. |
11. | Keep the area around your fireplace clear of combustible ma- |
| terials, gasoline, and other flammable vapor and liquids. Do |
| not run fireplace where these are used or stored. Do not place |
| items such as clothing or decorations on or around fireplace. |
12. | Do not use this fireplace to cook food or burn paper or other |
| objects. |
13. | Do not use any solid fuels (wood, coal, paper, cardboard, etc.) |
| in this fireplace. Use only the gas type indicated on the |
| nameplate. |
14. | This appliance, when installed, must be electrically grounded |
| in accordance with local codes or, in the absence of local codes, |
| with the National Electric Code, ANSI/NFPA 70, or the Ca- |
| nadian Electric Code, CSA C22.1. |
Upper
Louver
Panel
Glass
Door
Assembly
Lower 
Louver
Panel
Junction Box
Rear Vent
Flue Collar
Top Vent
Flue Collar
Door Latch
Log
Set
Ember
Tray
Nailing
Flange
Control Valve | Piezo Ignitor with |
Variable Input | Optional Remote and |
Adjustment | Blower Control Mount |
15. | Do not use fireplace if any part has been exposed to or under |
| water. Immediately call a qualified service person to arrange |
| for replacement of the unit. |
16. | Do not operate fireplace if any log is broken or missing. |
17. | Do not use a blower insert, heat exchanger insert, or other ac- |
| cessory not approved for use with this fireplace. |
18. | Do not operate fireplace with glass door removed, cracked, or |
| broken. |
19. | Provide adequate clearances around air openings. |
NOTICE: This product is intended only as a supple- ment to your central heating system and is not to be installed as a primary source of heat. You may use this product for emergency heating during a power outage.
Figure 1 - Rear / Top Direct-Vent Fireplace
LOCAL CODES
Install and use fireplace with care. Follow all local codes. In the absence of local codes, use the current National Fuel Gas Code
ANSI Z223.1/NFPA 54* (USA) or the current
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarh Park
Quincy, MA 02269
www.desatech.com |
