Desa (V) CD36T(N, (V) CD36R(N GAS Supply and Piping, High Altitude Installation, Check GAS Type

INSTALLING OPTIONAL CONTROLS

Continued

INSTALLING OPTIONAL WIRELESS REMOTE CONTROL - MODEL WRC (Electronic Ignition)

Installing and Activating the Remote Receiver

1.Open bottom louver and locate the plug receptacle. The plug receptacle is located either on the right or left side of cabinet.

2.The WRC model receiver does not require a battery. The re- ceiver can be installed by first plugging the short extension cord into the fireplace receptacle. Then plug the receiver unit into the extension cord. Finally plug the ignition module plug into the receiver unit (see Figure 45).

3.Activate the remote handset battery by removing the insulat- ing tab on the back of the handset (see Figure 46). The battery is included pre-installed.

4.Once the battery is activated the unit is ready to use.

INSTALLATING OPTIONAL CONTROLS (Cont.)	21
Installing Optional Wireless Remote Control - Model WRC

HIGH ALTITUDE INSTALLATION

GAS SUPPLY AND PIPING

Check Gas Type

Installing Gas Piping to Fireplace

When installing this fireplace in the USA at an elevation above 2000 feet (610 m), you may need to decrease the input rating by changing the existing burner orifice to a smaller size. Reduce input 4% for each 1000 feet (305 m) above sea level. Check with your local gas company for proper derate procedure and orifice size.

When installing this fireplace in Canada at an elevation above 4500 feet (1372 m), Check with local or provincial code authorities.

Consult your local gas company to help determine the proper orifice for your location.

For assistance with any high altitude installation contact DESA’s Customer Service Department at 1-866-672-6040.

GAS SUPPLY AND PIPING

5.Replace the bottom louver panel.

Fireplace
Receptacle	Remote Control
	Receiver

CHECK GAS TYPE

Use proper gas type for the fireplace unit you are installing. If your gas supply is not correct, do not install fireplace. See retailer where you purchased the fireplace for proper fireplace according to your gas type or to purchase gas conversion kit (see Accessories, page 43).

INSTALLING GAS PIPING TO FIREPLACE

		WARNING: A qualified service person must con-
	Ignition	nect fireplace to gas supply. Follow all local codes.
Extension Cord
	Module Plug	CAUTION: For propane/LP units, never connect
Figure 45 - Connecting WRC Remote Control Electronic		fireplace directly to the propane/LP supply. This
		heater requires an external regulator (not supplied).
		Install the external regulator between the fireplace
Battery Cover		and propane/LP supply.
12 Volt Battery
		External	Propane/LP
		Regulator	Supply Tank
Back of	Pull to Remove
Handset	Insulation Tab
Figure 46 - Installing Battery into Back of Handset		Vent
		Pointing
HIGH ALTITUDE INSTALLATION		Down
Your DESA direct-vent fireplace has been tested and approved in
the USA for elevations from 0-2000 feet (610 m) and in Canada		Figure 47 - External Regulator with Vent Pointing Down (Pro-
at elevations from 0-4500 feet (1372 m).		pane/LP Only)

116035-01B www.desatech.com