DeWalt D55695 English, Preparation For Use Pre-Start Checklist Fig, Initial Set-up Fig, Lifting

English

CAUTION: Risk of property damage. The wheels and handle do not provide adequate clearance, stability or support for pulling the unit up and down stairs or steps. The unit must be lifted, or pushed up a ramp.

When		transporting					the
compressor				in	a	vehicle,		r, s
trailer, etc. ensure that the air									R, S
tank is drained and the unit is
secured and placed on a flat
horizontal			surface.			NOTE:
Use recommended tie down
points (R) when transporting.								R	T
Use care when driving so to
avoid tipping the unit over in
the	vehicle.			Damage			can	r, S	r, s
occur to the unit or surrounding
items if unit is tipped. Use a
ramp if loading or unloading
the unit from a height of more									T
than 12" (30.5 cm).								R
Lifting
Warning: Risk injury from lifting. Unit weighs more than 160 lbs.
(72.6 kg) Do not move or lift without assistance.

Always use at least two people when lifting and lift from the recommended lift points (S).

MOVING

1.Grasp handle (T) of compressor, and lift compressor high enough so unit can be rolled on the front tire(s).

Warning: Risk of unsafe operation. Ensure proper footing and use caution when rolling compressor so that unit does not tip or cause loss of balance.

2.When location is reached slowly lower compressor to ground. Always store compressor in a horizontal position.

NOTE: Should the unit tip over, hard starting and smoking will occur due to oil spillage.

Preparation For Use

Pre-Start Checklist (Fig. 1)

1.Ensure engine START/RUN/OFF switch (C) is in the OFF position.

2.Ensure air tank is drained, see Draining Air Tank under Maintenance.

3.Ensure the drain valve (J) is closed.

4.Ensure safety valve (I) is functioning properly, see Checking Safety Valve under Maintenance.

5.Check pump oil level, see Compressor Pump Oil under Maintenance.

CAUTION: Do not operate without oil or with inadequate oil.DeWALT is not responsible for compressor failure caused by inadequate oil.

6.Check engine's oil and fuel level, see engine's instruction manual for correct procedures.

7.Visually inspect drive belt. Replace belt if frayed, cracked, or worn. NOTE: Outer belt cover must be removed to inspect drive belt.

8.Ensure all guards, covers, and labels are in place, legible (for labels) and securely mounted. Do not use compressor until all items have been verified.

Initial Set-up (Fig. 1)

WARNING: Do not operate this unit until you read this instruction manual and the engine instruction manual for safety, operation and maintenance instructions.

18