English
Code | possible cause | POSSIBLE SOLUTION |
|
|
|
22 | Engine problem | Contact a DeWALT factory service center or a DeWALT |
|
| authorized service center. |
|
|
|
23 | Engine or pump oil is low | Add DeWALT synthetic compressor oil to pump. See |
|
| Compressor Pump Oil under Maintenance. |
|
|
|
24 | Regulator is not adjusted correctly for accessory being | It is normal for some pressure drop to occur when an acces- |
| used | sory is used, adjust the regulator as instructed in Regulator |
|
| under Features if pressure drop is excessive. |
|
| NOTE: Adjust the regulated pressure under flow conditions |
|
| while accessory is being used. |
|
|
|
25 | Damaged regulator | Replace. |
|
|
|
26 | Detergent type oil being used in pump | Drain oil and refill pump with DeWALT synthetic compressor |
|
| oil. |
|
|
|
27 | Extremely light duty cycles | Run unit for longer duty cycles. It is recommended to run at |
|
| high throttle |
|
| run time. |
|
|
|
28 | Piston rings damaged or worn | Contact a DeWALT factory service center or a DeWALT |
|
| authorized service center. |
|
|
|
29 | Cylinder or piston damaged or worn | Contact a DeWALT factory service center or a DeWALT |
|
| authorized service center. |
|
|
|
30 | Compressor cylinder finish worn | Contact a DeWALT factory service center or a DeWALT |
|
| authorized service center. |
|
|
|
31 | Water in pump oil | Drain oil and refill pump with DeWALT synthetic compressor |
|
| oil. |
|
|
|
32 | Manual lock unloader lever in open position | Rotate manual lock unloader lever to the closed perpendicu- |
|
| lar position. |
|
|
|
30
