
16.Write the number(s) you circled into the blank in step 19.
17.Press and hold | until both SAT | T V lights turn | |
on (it takes about five seconds). |
| ||
18.Release | . SAT | light will flash. |
|
19.Press |
|
|
|
(Fill in this blank with the exact sequence you circled in Table 1)
20.Press the MUTE button while watching SAT light.
21.If the | SAT light flashes three times, go to step 22. | |
If | SAT | light does not flash at all, go back to step |
|
|
|
17. |
|
22.Press. If your TV tunes to Channel 3, go to step 23. If not, go back to step 15.
23.If you want to keep your satellite programming on TV Channel 3, check the box below and go to step 28.
3
24.If you prefer to have your satellite programming on TV Channel 4, check the box below and go to step 25.
4
25.In the blank below, write down the numbers you circled in Table 1, except replace “ 3” with “ 4.”
26.Cross out
27.Repeat steps 7 through 14 on page 9, including the changes you made to step 10.
28.You have completed setting up the button and TV control features of the remote control.
118866 | 11 |