Dish Network EZ manual Setting Up On The Remote Control

SETTING UP ON THE REMOTE CONTROL

1.In the blank below, write down your preferred off-

air channel that you want your TV to tune to when

you press .

2.If step 19 on page 11 is blank and was not used to set up , go to step 8. Otherwise, go to step 3.

3.In the blank below, write down the number sequence from step 19 on page 11.

4.If the number you wrote in step 1 is a 2-digit number: In the blank below, write the number sequence from step 3, except replace “ 3” or “ 0-3” with your 2-digit number from step 1 (for example, if you wrote “ 0-3-SELECT” in step 3 and your preferred channel is Channel 25, write “ 2-5-SELECT”).

5.If the number you wrote in step 1 is a 1-digit number: In the blank below, write the number sequence from step 3, except replace “ 3” with your 1-digit number from step 1 (for example, if you wrote “ 0-3- SELECT” in step 3 and your preferred channel is Channel 7, write “ 0-7-SELECT”).

6.Write the number sequence you wrote in either step 4 or step 5 into the blank in step 11 on page 14.

7.Go to step 9.

8.In the blank provided in step 11, write the number recorded in step 1. If that number has one digit, write “ 0” before the number.

9. Press and hold	until both SAT	T V lights turn
on (it takes about five seconds).
118866		13