Dish Network EZ manual None work, go to How to Scan for TV and VCR

SETTING UP THE REMOTE TO CONTROL YOUR TV

1.Find the brand name of your TV in the TV code tables starting on page 32. You will be referring to this location for codes in the instructions below.

2.Turn on your TV.

3.	Press and hold		until both SAT	T V lights turn
	on (it takes about five seconds).
4.	Release	. T V	light will flash.
5.	Press T V	. Notice	T V light turns on and stays on.

6. Enter one of the three-digit codes for your TV from the TV code tables while T V light is on.

Note: You have about 20 seconds to begin entering the TV code.

7.	Press the MUTE button and watch		T V	light.
	If T V	light flashes three times, the code is valid
	and you can go to step 8. If T V light does not flash
	at all, the code may not have been entered
	correctly. So, start over from step 3 and try the code
	again.
8.	Press	T V and your TV should shut off. If your TV
	shuts off, go to step 9. If not, pick another code for
	your TV brand from the TV Codes table and go
	back to step 3. If you have tried all of the codes and
	none work, go to How to Scan for TV and VCR
	Codes on page 21.
9.	Turn your TV back on by pressing		T V	again and
	try the other buttons below to make sure they work.

•Press the 0 through 9 buttons to change channels on your TV.

118866 7