DSCover Satellite Products PC1555MX Downloading, PGM Output Options, For Future Use

The panel has no way of confirming if the pager was called	PC-LINK, refer to your “PC-LINK Download Kit Instruction
successfully. A Failure To Communicate trouble will only be	Sheet”.
generated if the panel detects a busy tone on all dialing	NOTE: When a zone status upload is performed through PC-
attempts, or if no dial tone is detected on all dialing attempts.	LINK, the information uploaded may not be accurate. For more
The pager format will not cause any form of ringback.	information, refer to your DLS-1 manual.
NOTE: The Pager Format cannot be used with the LINKS1000	Downloading can also be performed through the LINKS1000
cellular communicator.
	cellular communicator if the telephone line is disconnected. If
NOTE: Do not use the digit C in a reporting code when using	using the LINKS1000 with call back, you need to program the
Pager Format. In most cases, the digit C will be interpreted as	LINKS1000 Preamble with the downloading telephone num-
a [#], which will terminate the page before it has finished.	ber in order for the panel to call the computer correctly.
NOTE: If the panel detects a busy signal, it will attempt to page	NOTE: When uploading labels from LCD keypads, only labels
	from the LCD keypad assigned to slot 8 will be uploaded.
again. It will make the maximum number of attempts pro-
grammed in section [160].
	Answering Machine/Double Call . . . . . . . . Section [401]: [1]
NOTE: Force dialing should be disabled when using Pager for-
	User Enable DLS Window . . . . . . . . . . . . . Section [401]: [2]
mat.
	Call-Back . . . . . . . . . . . . . . . . . . . . . . . . . . Section [401]: [3]
NOTE: When using Pager format, you must program two hex	User-initiated Call-up enabled/disabled . . . Section [401]: [4]
digit E’s at the end of the telephone number	Downloading Computer’s Telephone Number . Section [402]
5.10 Downloading	Downloading Access Code . . . . . . . . . . . . . . . Section [403]
	Panel Identification Code . . . . . . . . . . . . . . . . . Section[404]
The required downloading software is DLS-3 v1.3 and higher.	Answering Machine Double Call Timer . . . . . . Section [405]
Downloading allows you to program the entire control panel	Number of Rings to Answer On . . . . . . . . . . . . Section [406]
via a computer, a modem and a telephone line. All functions,	LINKS1000 Preamble (Downloading) . . . . . . . . Section [490]
features, their changes and status – such as trouble condi-	Initiate Local Downloading (PC-LINK) . . . . . . . Section [499]
tions and open zones – can be viewed or programmed
	5.11 PGM Output Options
through downloading.
NOTE: Downloading is always enabled for six hours each time	Program the programmable outputs by selecting one of the
the panel is powered up, unless the User Can Enable DLS	output options listed below (exceptions noted).
Window option is disabled
	Main Board PGM Outputs. . . . . . . . . . . . . . . . . Section [009]
The panel will answer calls for downloading when the pro-
	PC5208 PGM Outputs	. . . . . . . . . . . . . . . . . . . Section [010]
grammed Number of Rings is heard by the panel.	PC5204 PGM Outputs	. . . . . . . . . . . . . . . . . . . Section [011]
If the Answering Machine/Double Call option is enabled (or
	NOTE: PGM outputs cannot be completely disabled in
during the first six hours after power up), the panel will answer
incoming calls for downloading in the following manner:	installer’s programming. To disable a PGM output completely,
1. The panel hears one or two rings then misses a ring.	you must remove all wiring from the output.
2. At this point the panel will start a the double-call timer.	[01] Burglary and Fire Bell Output
3. If the panel hears another ring before the Answering
	The output will activate when the alarm output is active and
Machine Double-Call Timer expires, it will answer on the	will deactivate when the alarm output is silenced. If the alarm
first ring of the second call.	output is pulsing, the PGM output will pulse as well. This out-
The panel will immediately go on line and begin downloading.
	put will follow the activation of the alarm output (pre-alert) for
If the Call-Backoption is enabled, the panel and the com-
	delayed fire zones.
puter will both hang up. The panel will then call the Down-	[02] For Future Use
loading Computer’s Telephone Number and wait for the
	[03] Sensor Reset ([*][7][2])
computer to answer. Once the computer answers, download-
	NOTE: This output will normally be active (switched to ground).
ing will begin.
If the User Enabled DLS Window option is ON, the user can	This option is used to reset power for latching smoke detec-
activate the downloading feature by entering [*][6][Master	tors. The output will deactivate for five seconds when the
Code][5].	[*][7][2] command is entered. (See “[*][7] Command Output
If the User Initiated Call-Upoption is enabled, the user can	Functions” on page 11.) The keypad buzzer will not sound for
	the five second period.
have the panel initiate a call to the downloading computer by
	Please refer to the Control Panel Wiring Diagram in this man-
pressing [*][6][Master Code][6].
	ual for wiring instructions.
The Download Access Code and Panel Identifier Code are
	NOTE: Only ONE of Options [03] Sensor Reset, [04] 2-wire
for security and proper identification. Both the panel and the
	smoke, and [20] [*][7][2] Command Output Option #2 may be
computer file should contain the same information pro-
	programmed on the same system.
grammed before attempting to download.
The time to complete a successful download can be signifi-	[04] 2-Wire Smoke (PGM2 only)
cantly reduced with the use of the PC-LINK. This adaptor	When this option is selected, the PGM functions much like
makes it possible to perform on-site downloading. To Initiate	option [03] in that it is a normally low output supplying the
Local Downloading via the PC-Link, enter [*][8][Installer’s	negative return. However, 2-wire smoke detectors can be sup-
Code][499][Installer’s Code][499]. All keypads will be busy for	ported, meaning that a zone input need not be used. The 2-
the duration of the PC-LINK connection. The status LEDs will	wire smoke detector input is an instant and latching alarm.
display the current system status on the keypad where the	This input does not follow Swinger Shutdown.
PC-Link was initiated. For more information on connecting the	NOTE: 2-wire smoke is available on 50/300 versions only.

WWW.DIYALARMFORUM.COM

20