ADSL Router User Manual
Example – Static Route
Here provides you an example of Static Route.
For the LAN shown above, if the PC in the subnet of 192.168.1.x wants to access the PC in the subnet of 192.168.10.x, we can set a static route in the ADSL router, in which the destination is the PC in the subnet 192.168.10.x and the gateway is router B. The setting would be as follows:
Destination: 192.168.10.0
Netmask: 255.255.255.0 (Standard Class C)
Gateway: 192.168.1.254 (Router B)
IP Routing – Dynamic Routing
Routing Information Protocol (RIP) is utilized by means of exchanging routing information between routers. It helps the routers to determine optimal routes. This page allows you to enable/disable this function.
RIP Version:
It incorporates the RIP information when receiving and broadcasting the RIP packets. From the drop down menu, select a RIP version to be accepted, 1, 2 or both.
Operation:
There are two modes for you to choose, Active and Passive. Select Active for transmitting and receiving data, or select Passive for receiving data only.
Enabled:
Check Enabled to enable the RIP function on different interface. Otherwise, disable this function.
Click Apply to invoke the settings set here.
90
