Edimax Technology BR-6478Gn user manual ‐4‐1‐5 AP Bridge-WDS

	to connect to this router.
	2.4GHz (N): Allows 802.11n wireless network clients
	to connect to this router.
	2.4GHz (B+G): Allows 802.11b and 802.11g wireless
	network clients to connect to this router.
	2.4GHz (G): Allows 802.11g wireless network clients
	to connect to this router.
	2.4GHz (B+G+N): Allows 802.11b, 802.11g, and
	802.11n wireless clients to connect to this router
	(recommended).
Channel Number	Select a channel from the dropdown menu. All access
	points must use the same channel (1 to 13).
MAC Address 1 to 4	Input the MAC addresses of the wireless access points
	with which you wish to connect.
Wireless Module	Select “Enable” to turn on the 2.4GHz wireless
	signal and select “Disable” to turn it off.

Click “Apply” to save the changes, or click “Cancel” to discard the changes. After you have clicked “Apply”, you will see the following message:

Click “Apply” to save the changes and restart the broadband router. It takes about 60 seconds for the broadband router to restart. Click “Continue” to configure other settings.

3‐4‐1‐5 AP Bridge—WDS

In “AP Bridge—WDS” mode, this broadband router acts as both a wireless communication bridge and a wireless access point. This router can connect to up to 4 WDS‐compatible wireless access points and allows the computers connected every AP to communicate with each other.

44