Chapter 7 Use of Serial Port
Control the projector with Telnet
This product allows you to control the projector by using the Telnet application. Normally, it is used for controlling the external equipment connected to the serial port and also control the projector itself by specifying the telnet port no.10000.
*It is not affected by the serial port setting of the projector when using the telnet appli- cation.
In the step 2 of the previous page, enter port no. “10000” after the IP address no. > open 192.168.1.201 10000 return
* Use the IP address assigned to the pro- jector
After the communication is established, type the password and the command for controlling the projector and then enter “Enter” key.
The right table shows the typical command lists for controlling the our projector and please consult your local dealer for further information of another commands.
Command list table
Command | Function |
|
|
C00 | Turn the projector on |
C01 | Turn the projector off |
C05 | Selects input1 |
C06 | Selects input2 |
C07 | Selects input3 |
C08 | Selects Network |
C09 | Volume up |
C0A | Volume down |
C0B | Mute on |
C0C | Mute off |
C0D | Video mute on |
C0E | Video mute off |
C1C | Menu display on |
C1D | menu display off |
|
|
92
