Preparations

Hardware Preparation and Installation

 

 

zEnsure that your sleeves are tightened or rolled up above the elbow. For safety purpose, it is not recommended to wear jewelry, watch, glasses with metal frame, or clothes with metal buttons.

zDo not exert too much force, or insert or remove the components forcibly. Avoid damage to the components or plug-ins, for example, the pins are bent or get short circuit.

2.6.2Preparations

Before you install or replace a component, make the following preparations

zConfirming the feasibility of the operation

There are available spare parts of the component to be installed or replaced in the equipment warehouse. When the available spare parts are in short supply, contact Emerson Network Power Embedded Computing for help in time.

Make sure that the new component is in good condition, without defects such as oxidation, chemical corrosion, missing component, or transportation damage.

By reading this document, you are familiar with how to install and replace the component and master the skills required by the operation.

zChecking the environment

Make sure that the shelf, power supply, temperature, and humidity meet the operating requirements of the blades and components. For details, refer to ATCA-7350 Installation and Use Manual and other related documents.

zPreparing spare parts and tools

Prepare the component to be installed or replaced.

When you hold or transport the component, use the special antistatic package. In addition, you need to tidy, record, and repair the component during routine maintenance.

Prepare the cross screwdriver, screws, plastic supports, cooling gel, and ESD- preventive wrist strap.

The supplier provides a list of tools and negotiates with you to decide the tool provider.

zConfirming installation or changing positions

Confirm the positions of the cabinet, the shelf, and the slot where RTM-ATCA-7350 is installed. Then, stick a label on the face plate of RTM-ATCA-7350 to avoid wrong operation.

zOthers

If a serious problem occurs and cannot be solved when you install or replace the component, contact Emerson Network Power Embedded Computing for technical support.

2.6.3GE Daughter Card

This manual considers the GE daughter card providing two external Ethernet interfaces as an example, and describes how to install the daughter card on and remove it from RTM-ATCA- 7350.

RTM-ATCA-7350 Installation and Use (6806800H30F)

25

Page 25
Image 25
Emerson RTM-ATCA-7350 manual GE Daughter Card, Preparations Hardware Preparation and Installation