Hardware Preparation and Installation | FC Daughter Card |
| |
After installation, check if RTM-ATCA-7350 can be powered on and work normally. Use the network cable to connect RTM-ATCA-7350 to the external network. Check if the network is connected properly and monitor whether the network port indicator is normal.
2.6.3.3Replacing the GE Daughter Card
To replace the GE daughter card, proceed as follows.
1.Wear the ESD-preventive wrist strap. For more information refer, Wearing the ESD- Preventive Wrist Strap on page 21.
2.Remove the RTM-ATCA-7350whose GE daughter card is to be replaced. For more information refer, Removing RTM-ATCA-7350on page 32.
3.Open the plastic latches fastening the GE daughter card.
4.Exert even force upwards until the daughter card connector is removed from the connector on RTM-ATCA-7350. Remove the daughter card by facing the daughter card at an angle of 45° to the RTM.
5.Place the removed GE daughter card in an antistatic package.
6.Take the new GE daughter card out of the antistatic package.
7.Insert the GE daughter card in RTM-ATCA-7350 by facing the daughter card at an angle of 45° to the RTM. Align the daughter card connector with the connector on RTM-ATCA-7350, and the daughter card positioning holes with the plastic supports on RTM-ATCA-7350. Exert even power downwards until the daughter card connector is fully inserted into the connector on RTM-ATCA-7350 and the daughter card is fastened by the plastic latches.
8.Install RTM-ATCA-7350whose GE daughter card is replaced. For more information refer, Installing RTM-ATCA-7350on page 30.
After replacement, check if RTM-ATCA-7350 can be powered on and work normally. Use the network cable to connect RTM-ATCA-7350 to the external network. Check if the network is connected properly and monitor whether the network port indicator is normal.
2.6.4FC Daughter Card
This section describes how to install the daughter card on and remove it from RTM-ATCA-7350.
2.6.4.1Installation Positions
When the FC daughter card is used with the RTM-ATCA-7350 it can be installed on the daughter card connector J1. The RTM-ATCA-7350 provides space for one FC daughter card. Use of the FC daughter card excludes use of the GE daughter card.
28 | RTM-ATCA-7350 Installation and Use (6806800H30F) |
