Enterasys Networks 6H308-48, 4H4285-49 manual Connecting a Twisted Pair Segment with RJ45 Connector

Connecting to the Network

To connect and verify UTP cable connections to RJ45 ports 1 through 48, refer to Figure 3‐4 and proceed as follows:

1.Ensure that the device connected to the other end of the segment is powered ON.

2.Insert the RJ45 connector on the twisted pair segment into the appropriate RJ45 port connector.

Figure 3-4 Connecting a Twisted Pair Segment with RJ45 Connector

	FAST ENET
	4H4285-49
		OFFLINE/
		RESET
	COM
Á			Â
À	MGMT	CPU	RX
	POE
		GROUP
		SELECT
	GROUP
	1	1
	1
	2	2
	2
	3	3
	3
1	4	4
	4		TX
		6
		5
		7
		8
		9
11X	12 X	10
		11
		12

1 RJ45 cable connector 2 RJ45 port connector 3 GROUP SELECT button

3.Verify that a link exists by checking that the port RX (Receive) LED is ON (flashing amber, blinking green, or solid green). If the RX LED is OFF and the TX (Transmit) LED is not blinking amber, perform the following steps until it is on:

Note: If the RX and TX LEDs of a port do not indicate a link and the end-point device is a PD, you may have a port without 48 Vdc to operate the PD. To check the PoE Port Status, refer to “Verifying PoE Port Status” on page 3-17.

a.To view the receive and transmit activity on a group of segments, press the GROUP SELECT button for less than one second (see Figure 3‐4) to step to the group of interest (Groups 1 through 4).

b.Each time the GROUP SELECT button is pressed for less that one second, the GROUP LED lights up in sequence, indicating which Group is selected. The receive and transmit activity for that group of segments is then indicated by the RX and TX LEDs for each segment.

3-14 Installation