Enterasys Networks C2H124-48P, C2G124-48P manual Introduction, Overview

1

Introduction

This chapter introduces the C2G124‐48P and C2H124‐48P Gigabit Ethernet stackable switches.

Important Notice

Depending on the firmware version used in the switch, some features described in this document may not be supported. Refer to the Release Notes shipped with the switch to determine which features are supported.

For information about...	Refer to page...
Overview	1-1
PoE (Power over Ethernet) Support	1-5
Connectivity	1-6
Management	1-6
Standards Compatibility	1-7
LANVIEW Diagnostic LEDs	1-7
Getting Help	1-7

Overview

The C2G124‐48P and C2H124‐48P are stackable switches that can be adapted and scaled to help meet your network requirements. These switches provide a management platform and an uplink to a network backbone for a stacked group of up to eight C2 switches.

The switches also support the use of a redundant DC power supply to help prevent downtime due to an internal power supply failure in the switch or AC power source.

You can install the switch on a flat surface or into a standard 19‐inch rack with user‐ supplied mounting hardware, and configure the switch functions using the WebView™ application, CLI switching commands, and/or SNMP.

SecureStack C2 Installation Guide 1-1