Standards Compatibility
Switch Configuration Using CLI Commands
The CLI commands enable you to perform more complete switch configuration management tasks.
For CLI command set information and how to configure the module, refer to the SecureStack C2 Configuration Guide.
Standards Compatibility
The switches are fully compliant with the IEEE 802.3‐2002, 802.3ae‐2002, 802.3af‐2002, 802.1D‐1998, and 802.1Q‐1998 standards. The switches provide IEEE 802.1D‐1998 Spanning Tree Algorithm (STA) support to enhance the overall reliability of the network and protect against “loop” conditions.
LANVIEW Diagnostic LEDs
LANVIEW diagnostic LEDs serve as an important troubleshooting aid by providing an easy way to observe the status of individual ports and overall network operations.
Getting Help
For additional support related to the module or this document, contact
Enterasys Networks using one of the following methods:
World Wide Web | http://www.enterasys.com/services/support |
|
|
Phone | |
| For the Enterasys Networks Support |
| www.enterasys.com/services/support/contact/ |
|
|
Internet mail | support@enterasys.com |
| To expedite your message, please type [SWITCHING] in the subject line. |
To send comments or suggestions concerning this document to the Technical Publications Department:
techpubs@enterasys.com
To expedite your message, please include the document Part Number in the email message.
Before contacting Enterasys Networks for technical support, have the following information ready:
•Your Enterasys Networks service contract number
•A description of the failure
SecureStack C2 Installation Guide
