Enterasys Networks C2G124-48P, C2H124-48P manual Using the Reset Button

Using the Reset Button

Table 4-2 Troubleshooting Checklist (continued)

Problem	Possible Cause	Recommended Action
Port(s) goes into	Loop condition detected.	Verify that Spanning Tree is enabled. Refer to the
standby for no		SecureStack C2 Configuration Guide for the instructions to
apparent reason.		set the type of STA.
		Review the network design and delete unnecessary loops.
		If the problem continues, contact Enterasys Networks for
		technical support.
User parameters	Clear NVRAM was set using	Reenter the lost parameters as necessary. Refer to the
(IP address, device	CLI commands.	SecureStack C2 Configuration Guide for the instructions to
and module name,		configure the switch using CLI commands.
etc.) were lost		If the problem continues, contact Enterasys Networks for
when the switch
		technical support.
power was cycled.

Using the Reset Button

If you forget the switch login password, use the Reset button as described in the following procedure.

Figure 4-3 Reset Button

À

1Reset button

4-8 Troubleshooting