Viewing Hardware Types | Enterasys Networks FN 100 instruction

The FN100 Chassis View

The MIBs which provide the FN100’s functionality

—both proprietary MIBs and IETF RFCs — are listed here.

MIB Components are listed here; remember, there’s no one-to-one correspondence between MIBs and MIB Components.

Figure 2-3. Chassis Manager Window

Viewing Hardware Types

In addition to the graphical displays described above, menu options available at several levels provide specific information about the physical characteristics of the FN100 and its ports.

Viewing the Device Type

Choosing the Device Type... option on the Device menu brings up a window that describes the management device being modeled:

Figure 2-4. Device Type Window

Viewing the Port Description

Choosing the Description... option on the individual port interface menus brings up a window that describes that interface you have selected. Depending on the type of port you select, one of the following windows will appear:

2-10	Viewing Chassis Information

Image 26

Enterasys Networks FN 100 manual Viewing Hardware Types, Viewing the Device Type, Viewing the Port Description

Contents

FN 100 User’s Guide Page Virus Disclaimer Page Restricted Rights Notice Page Contents Index Chapter Using FN100 TrunkingChapter Workgroup Configuration Using the FN100 User’s Guide Introduction Related Manuals Software Conventions IP Address Common FN100 Window FieldsDevice Name Location Port Number Using the MouseMAC Address Uptime Using Window Buttons Getting Help from the Global Technical Assistance Center Using On-line HelpGetting Help Introduction Introduction Getting Help FN100 Chassis View Connection Status Viewing Chassis InformationFront Panel Information Firmware Boot PromPort Status Time Menu Structure Device Menu Port Status Menu Port Menus Utilities MenuHelp Menu Status FN100 Port Status DisplaysSelecting a Port Status View Mapping ErrorsLoad Speed Port Status Color Codes Chassis Manager WindowType Viewing the Port Description Viewing Hardware TypesViewing the Device Type Using Device Find Source Address Managing the Hub Component Port Instance Viewing I/F Summary Information Physical Status IndexDescription Logical Status Raw Counts Rate Viewing Interface Detail Unicast ErrorAddress Non-Unicast Making Sense of Detail Statistics Alignment Receive ErrorsViewing Csmacd Statistics Transmission Errors Collision Errors Enabling and Disabling Ports To enable or disable a bridge port FN100 Virtual Switching Performing Virtual Switching Configuring Your Virtual Switch Settings Update Defining a Default Switch Change Default Switch Window FN100 Virtual Switching Performing Virtual Switching Using FN100 Trunking Port Trunking Window State Rmt IP Address Last ErrorRmt Bridge Id Last Change Link OrdinalLink Count Clear Enabling and Disabling Trunking Using FN100 Trunking Port Trunking Window Workgroup Configuration Configuring a Workgroup Workgroup Configuration Deleting a Workgroup Workgroup Configuration Configuring a Workgroup Index Index-2